The stuff we build & do:
Assistance for developing new IOT devices.
Including software development & hardware prototyping.
In-house development of custom electronic circuitboards.
Development of custom computer software on request.
Configuration of network equipment.
Assistance in choosing correct network equipment.
Assistance in choosing fitting backup systems.
Configuration of cloud based backups.
Configuration of on-site backups with optional off-site synchronisation.
Assistance in selecting quality hardware.
Assembly and configuration.
By using-open source where possible, we are able to deliver improved security, privacy and unlimited free updates.
By combining open-source and our own software, we maintain full controll to provide updates and bug-fixes.
Clients get their own secure wiki page, where we provide all project documentation.
Remote monitoring of user specific installations to provide preventive actions and support.
Xnorit is a small company, specialised in development of embedded systems (hardware & software).
Each node contains an additional digital input for instant sensing of irregularities, used in conjunction with the freezers relay-alarm port.
Using Zigbee, each node acts as a repeater (range extender), making range issues improbable.
Integrated secondary temperature sensor for cold-junction compensation.
Publicaly available dashboard Click here to view dashboard.
Thermocouple measuring range: -270°C up to +1800°C
Xnorduino dashboard compatible!
Includes interal audible alarm (Buzzer), with three preconfigured temperature configurations.
Includes two cr2032 backup batteries to send warnings to the end user during power-outages.
Contains three switches: 1 bi-state to disconnect the battery, 1 bi-state to swap from legacy mode to xnorduino mode, 1 tri-state for temperature configuration.
When powered from battery the system falls into battery saving mode, turning off and on parts off the circuitboard on an 8 seconds interval. (8s off, less than 1s on).
Fault or degraded performance detection on communication bus.
Additional 12V or 24V input for motors, relays, power-leds, etc...
Integrated voltage monitoring on termination brick
Powered over USB or Raspberry pi GPIO
XBEE THT wireless addon connector
Arduino IDE compatible
Using the Zigbee mesh protocol, each node acts as a repeater (range extender), making range issues improbable.
Additional uart expansion port is available for future addons (temperature, light, humidity, movement ... sensors).
The circuitboard is powered from the same 12VAC supply that powers the led-lights. No battery is required.
Each Circuitboard has two seperate controlable output channels to connect the led-lights too.
Circuitboards can be dazy-chained, removing the need for additional junction boxes.
Please fill out the form below to send us an email and we will get back to you as soon as possible.
Phone +32 (0)498/62.78.98
Email Please use the contact form.
